160L Corrosive/Agri-Chemical/Toxic Goods Shelf

You can see that there are holes in the bottom of the 2 Vees folded into our shelves allowing free air movement.

Apart from these vees being designed to strengthen the bottom of the shelf to hold the maximum amount, there is a slight angle difference at the first and last 88 degree bend on the outer side of the shelf (top and bottom of the photo) Hardly noticeable that it is under 90 degrees, but this directs any spillage away from the doors and back wall and into the vees . It also means that any spillage would eventually drain into the vees and not leave the drums on the shelf sitting in a slimy poisonous mess as the common shelves of many non compliant cabinets do.

Should there be a large spillage over our shelf, then the holes in the vees would not cope and the liquid would over flow the air holes but continue to be directed to the outer of each side where it will spill into the bund . The ends of the vees are not sealed.

Trays – 980mmW x 370mmD x 40mmH

Made from 8mm thick Polypropylene.  Acid resistant and no known chemical can permeate through this material.

Resources